flange造句,用flange怎么造句子(30句)

flange造句,用flange怎么造句子

1、double-studded flange『2words』

2、open-flange flow cross『3words』

3、propeller shaft pinion flange『4words』

4、flange bobbin for warping(cotton)『4words』

5、rear axle bevel pinion flange『5words』

flange造句,用flange怎么造句子

6、concentric orifice with flange taps『5words』

7、Remove holder and coolant flange.『5words』

8、flange ，tin， for tubes or pipes『6words』

9、flange ，zinc， for tubes or pipes『6words』

10、Using thread or flange capillary connection.『6words』

flange造句,用flange怎么造句子

11、The rotationally symmetrical flange facilitates mounting.『6words』

12、Seat Face： Negates need for flange gaskets.『7words』

13、Mounting mode： foot-mounted， flange-mounted， torque arm-mounted， small flange-mounted.『8words』

14、Radial ball bearings with flanged outer ring--Flange dimensions『8words』

15、Many flange for rotating： circular flange and square flange.『9words』

16、Refer to Table1 for flange classifications and serial parameters.『9words』

17、Some fittings and equipment have built-flange， flange connection also belongs.『10words』

18、Allow the sleeve flange to return to its original position.『10words』

19、With the NEMA standard flange connection， keep the good universal.『10words』

20、Specification for metallic ring gaskets for steel pipe flange joints『10words』

flange造句,用flange怎么造句子

21、Angle flange Standard. Flat flange： Specify hole pat-tern. If no drawing provided， flange will be blank.『16words』

22、Retighten all flange bolts in a star pattern in order to extrude rubber sleeve flange material.『16words』

23、I plant mainly produces all kinds of high， medium， low flange， ring， forging， gear and special flange.『17words』

24、The second crack is a crack originating at the groove weld toe of the column flange-girder flange connection.『18words』

25、ANSI flange sealing principle is very simple： bolt two seal face mutual extruding flange gaskets and formed the seal.『19words』

26、“This allows interchangeability of gear operators， actuators， and adapter bushings from valve mounting flange to extension stem top flange."『19words』

27、It's a fixing flange with an easy pre-load regulation system. The flange is completely finished， ready to be used.『19words』

28、Starting at the forward end of the upper molding， force the molding onto the door panel flange and continue rearward until it is completely seated on the flange.『28words』

29、Girth flange bolting shall be of stud bolt type， threaded full length， and at least M16 for flange of 600 mm and smaller inside diameter and at least M20 for over 600 mm inside diameter flange.『36words』

30、Corresponding sizes of class 150 (aNSI B16.24) flange diameters and drilling templates are the same as those of the american Class 125 Cast Iron Flange Standard (aNSI B16.1) and of the american Class 150 Steel Flange Standard (aNSI B16.5).『39words』

以上是为大家整理的“flange造句,用flange怎么造句子(30句)”，转载请注明：https://www.pp-health.com/juzi/352105.html。